商洛附近想过夜电话联系

Hello! Welcome to the official website of shanteng transmission electromechanical Co., Ltd!
Set as home page Add to collection Website map Distribution: Foshan, Taiwan, Hong Kong
  • Office address: 3 / F, block D, east of Lianhe Avenue, Luocun street, Nanhai District, Foshan City, Guangdong Province
  • TEL:0757-63836968 / 86401667
  • MOBIEL: 15118744777
  • FAX:0757-86401607
  • EMAIL:2486877456@qq.com
  • How about forgetting to change the lubricating oil of Yamato direct cross shaft reducer

    Time: 2020-03-18 16:28:25 source: shanteng transmission second
    Whether it is the Yamato direct axis reducer, hollow shaft reducer or other brands of reducer products, in the process of use, it is an indispensable thing to add lubricating oil to the reducer and change the lubricating oil. Some manufacturers will add lubricating oil when the reducer leaves the factory, such as shanteng Some manufacturers do not add lubricating oil to the reducer. Whether the reducer is lubricated or not, e.g Rattan Orthogonal axis Reducer After using for a period of time, the lubricating oil needs to be changed.
     Yamato straight axis reducer
     
    If you forget to replace it Yamato straight axis reducer What happens to the lubricating oil? For some reducer combinations with high output speed or input speed, long-term high-speed operation will make the friction larger and produce more heat. If it is a new lubricant, it can reduce friction At the same time, it prevents more heat production. However, if the reducer runs at high speed without changing the lubricating oil for a long time, the internal lubricating oil becomes extremely thick and may contain impurities. There are two possible outcomes. One is abnormal noise, the other is temperature rise.
     
    When the lubricating oil becomes thick and contains impurities, it will accelerate the wear between the reducer gears, and the gear wear of the reducer may cause tooth beating, and the impact of more and more impurities on the gear will be greater and greater. So it will cause abnormal noise, which may be Uneven.
     
    In addition, the temperature rise of reducer is caused by the increase of friction, and the temperature rise is caused by the increase of friction. In the case of only one air hole, and the size of the air hole is not large, the heat generated due to friction can not be discharged in time, so the temperature is It will accumulate higher and higher.
     
    be used Yamato straight axis reducer When do you need to change the oil? If the internal lubrication of the worm gear is very thick after 2000 hours of operation, if it is not conducive to the internal lubrication of the worm gear.
     
    Otherwise, the gear or worm gear is damaged, which will damage the reducer and even lead to the loss of the whole reduction equipment. That would make the consequences much more serious.

    Last article: Shanteng reducer output shaft direction how to confirm, the manufacturer to explain
    Next: Suggestions on measures to solve the problem of reducer

    
    阜阳缘来客

    商洛附近想过夜电话联系